Makerbot 3D打印机装配教程 2.Z-Stage Assembly(Z轴平台装配)
Building the Z Stage should take approximately 15 minutes.Parts ListThese are the parts you’ll need to assemble the Z Stage. All laser-cut parts should have their names etched into them. Find and put aside these parts:[*]Laser-cut Stage Parts
[*]Z Back
[*]Z Top
[*]Z Bottom
[*]Z Left Side
[*]Z Right Side
[*]Z Ribs
[*]One Z Motor Flange*
[*]Four (4) M3x10 socket cap bolts or Four (4) M2x10 socket cap bolts with nuts*
[*]Eighteen (18) M3x16 socket cap bolts
[*]Eighteen (18) M3 nuts
[*]Four (4) 3/8″ self-aligning bearings*
*These parts should have been put in place during the preparation stage.
Attach Ribs to BackParts needed:
[*]2 Z Ribs
[*]Z Back
[*]2 M3x16 socket cap bolts
[*]2 M3 nuts
Secure the two Rib pieces to the Back. These ribs are symmetrical, so they just need to look like the picture.
Attach Left, Right and Bottom to BackParts needed:
[*]Assembled back
[*]Z Left
[*]Z Back
[*]11 M3x16 socket cap bolts
[*]11 M3 nuts
Secure the Left and Right sides to the Back. In the newest versions the printed text goes right-side-up on the inside. In older versions (pictured below) the printed text goes on the outside and ends up upside-down. After securing Left and Right sides, attach to theBottom (pay attention to the orientation of the self-aligning bearings).
Attach Top to AssemblyParts needed:
[*]Assembled back
[*]Z Top (from preparation stage)
[*]6 M3x16 socket cap bolts
[*]6 M3 nuts
This will lock things in place nicely. This piece is also symmetrical.Tighten It All DownNow that it’s all together, tighten all the bolts with 1/4- to 1/3-turns past hand tight.Congratulations! Your Z Stage is now complete!
页:
[1]